Innovating science for over 130 years

Request a Quote Form

DH410C – DH412 High Performance Fine Ovens

Phased out:
Yamato DH410C
Upgrade to our new replacement product:
Yamato DH412

Common Specifications:

  • System: Forced convection
  • Internal capacity: 91L
  • Internal dimensions: 450×450×450 mm (W×D×H)
  • External dimension: 1050 × 630 × 850 mm (W×D×H)
  • Power source: 220V

Old vs. New

Upgraded Product Specifications

ModelPhased-out Model DH410CReplacement Model DH412
Temperature rangeRT +40°C ~ 360°CRT +15°C ~ 360°C
Temperature control deviceModel IVCRModel V for improved temperature control and added functions
Cable port30 mm33 mm
Operation functionFixed temperature, Program operation (max. 30 steps, repeat operation), Auto start, Auto stop, Quick auto stopFixed temperature, Program operation (max.99 steps, up to 99 patterns repeat operation), Duration / time select timer operation function (fixed temperature operation, auto-start, auto-stop, quick auto stop, program operation auto start)
Additional functionsLock function, Power recovery mode, Calibration offsetVariable air flow function,
Power on and Operation Time Integrating Function (up to 65,535 hours); Calibration Offset; Power Recovery Mode, Monitor Display for Accumulated Power Consumption, Total CO2 Emission, and Heater operating Output; Save and Access of Operator’s Setting Information
Safety devicesSelf-diagnostic functions (detection for temp. sensor failure, triac short circuit, heater line disconnect, main relay contact damage and overheating), keypad lock functionSelf-diagnostic functions (detection for temp. sensor failure, triac short circuit, heater line disconnect, main relay contact damage and overheating), keypad lock function, fan motor error detection
Other enhancements of replacement modelInsulation material changed which yielded shorter ramp times

New door switch

Door hinges changed to adjustable butterfly hinge to eliminate door seal gaps
County manufacturedChinaJapan

For complete technical specifications of the phased-out model, contact Customer Service.